Reverse Idler Gear Assembly Shim

This procedure must be performed with the reverse idler gear assembly installed in the transaxle case.

1. Set measuring base tool No. J-39457 and dial indicator tool No. J-800O1, or equivalents, on mating surfaces of clutch and differential housing.

2. Place dial indicator measuring tip on surface of case where thrust washer seats and set to 0.050 inch.

3. Place dial indicator and base on mating surface of transaxle case.

4. Measure top of thrust washer (99).

5. Calculate difference between 0.050 inch and reading at thrust washer.

6. Choose thrust washer (99) from kit to achieve axial play of 0.006-0.010 inch.