Operation CHARM: Car repair manuals for everyone.

Valve Rocker Arm and Push Rod Installation

TOOLS REQUIRED
J 36660 Torque Angle Meter or equivalent.





PROCEDURE
1. Install the push rods.
2. Install the rocker arms.

CAUTION: This bolt is designed to permanently stretch when tightened. The correct part number fastener must be used to replace this type of fastener. Do not use a bolt that is stronger in this application. If the correct bolt is not used, the parts will not be tightened correctly. The system or the components may be damaged.

3. Apply thread lock compound or the equivalent to the rocker arm bolt threads.
4. Install the rocker arm bolts.
^ Tighten the bolts to 15 Nm (11 ft. lbs.) Plus 90 degrees using the J 36660.