Service Procedure

1. Raise and support the hood. Write down the owner's preset memory settings which will be lost when the battery is disconnected for reference later when resetting the memory functions. If a memory retention device is plugged into the cigarette lighter socket (such as "memor-eze", Snap-on tool YA960, or kent moore tools KS295A or BT 9027), this step can be omitted. Then, with the ignition in the "OFF" position, disconnect the negative battery cable.

2. Remove right side sound insulator (from below instrument panel).





3. Reposition carpet around lamp control module (see figure 1).

4. Remove lamp control module from mounting bracket.

5. Disconnect connectors (2) from Lamp Control Module.

6. Install connectors to new lamp control module and install module into mounting brackets.

7. Reinstall carpet and right sound insulator panel.

8. Reconnect negative battery cable. If memory retention device was not used, please reset (to the extent possible) all devices that lost their memory after the battery was disconnected.

9. Check for proper operation of exterior lamps.

10. Install campaign identification label.