Automatic Transmission

Diagnostic Trouble Code (DTC) 83:

DTC 83 Circuit:

CIRCUIT DESCRIPTION
The Torque Converter Clutch (TCC) Pulse Width Modulated (PWM) solenoid is used in combination with the TCC solenoid to regulate fluid to the torque converter and is attached to the control valve body within the transmission.

The Powertrain Control Module (PCM) supplies a ground allowing current to flow through the solenoid coil according to the duty cycle (percentage of "ON" and "OFF" time). This current flow through the solenoid coil creates a magnetic field that magnetizes the solenoid core. The magnetized core attracts the check ball to seat against spring pressure. This blocks the exhaust for the TCC signal fluid and allows 2-3 drive fluid to feed the TCC signal circuit. The TCC signal fluid pressure acts on the TCC regulator valve to regulate line pressure and to apply fluid pressure to the torque converter clutch shaft valve. When the TCC shift valve is in the apply position, regulated apply fluid pressure is directed through the TCC valve to apply the torque converter clutch.

DIAGNOSTIC TROUBLE CODE (DTC) WILL SET WHEN
- The PCM commands the solenoid "ON" and voltage remains high (B+) for two seconds.
- The PCM commands the solenoid "OFF" and voltage remains low (zero volts) for two seconds.

ACTION TAKEN (PCM WILL DEFAULT TO)
No TCC will occur and no 4th gear if in hot mode. DTC 83 will be stored in the PCM memory but will not turn "ON" the Malfunction Indicator Lamp. (MIL)

DTC 83 WILL CLEAR WHEN
The fault condition(s) no longer exist, and the ignition switch is cycled "OFF" then "ON."

CHART TEST DESCRIPTION
Number(s) below refer to circled number(s) on the diagnostic chart.

1. This test will check if the PCM is commanding the TCC solenoid "ON."
2. This test will check for voltage to the solenoid.

DIAGNOSTIC AIDS
Check all connections at the transmission pass-thru connector.If they
are OK, refer to Diagnosis by Symptom.