Troubleshooting Hints

Perform before beginning System Diagnosis
1. Check PWR ACCY Fuse 7 in I/P Fuse block. If open, refer to Diagnostic Chart# 4. Chart 4 Repeatedly Blows Whenever Ignition Is on
2. Check for poor connection at G200.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (Refer to "Diagnostic Aids/General Troubleshooting Procedures,". Diagnostic Aids
^ Refer to System Diagnosis. System Diagnosis