Troubleshooting Hints

Perform before beginning System Diagnosis.
Important:
^ To avoid misdiagnosis, check linkage for mechanical binding which would prevent connect system operation.

1. Check Windows Circuit Breaker 15 for an open. If open. check for a short to ground through CKTs 341, 162 and 163.
2. Check that G2O1 is clean and tight.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible. should be checked by monitoring for a voltage drop with the system operational (under load).
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (Refer to "Diagnostic Aids/General Troubleshooting Procedures,"). Diagnostic Aids
^ Refer to System Diagnosis. [1][2]Symptom Table