Oil Pump Removal and Installation

OIL PUMP ASSEMBLY






REMOVE OR DISCONNECT
1. Oil pan assembly. Service and Repair
2. Pump and drive shaft extension.

IMPORTANT: Refer to Oil Pump Disassembly/Assembly for cleaning, inspection and repair.

INSTALL OR CONNECT

FASTENER NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Oil pump and driveshaft extension.
2. Engage drive shaft extension into drive gear.
3. Pump to rear bearing cap bolt.

TIGHTEN
- Bolt/screw to 41 Nm (30 lb. ft.).

4. Oil pan assembly.
5. Fill Crankcase with oil.