Air Cleaner Housing: Service and Repair

Air Intake System Component:

Air Cleaner Support:

AIR FILTER / UPPER AIR CLEANER
Remove or Disconnect
1. Air cleaner screws.
2. Upper air cleaner.
3. Air cleaner filter from upper air cleaner.

Inspect
Air cleaner filter for dust dirt, water and replace if required.

INSTALL OR CONNECT
1. Air cleaner filter to upper air cleaner.
2. Upper to lower air cleaner.
3. Air cleaner screws.

Tighten
Screws to 6 Nm (53 lb. in.).

REMOVE OR DISCONNECT LOWER AIR CLEANER
1. Front air intake duct push in retainer.
2. Attaching bolt from lower air cleaner.
3. Loosen clamp on rear air intake duct and position rear air intake duct out of the way.
4. Lower air cleaner from vehicle.


INSTALL OR CONNECT
1. Lower air cleaner to vehicle.

NOTICE: Insure that the engaging pins are properly located and intake duct is sealed to the intake resonator and front intake duct.

2. Position rear air intake duct onto lower air cleaner.

NOTICE: If replacing the rear air intake duct be sure to transfer the Intake Air Temperature (IAT) sensor to the new duct. Just grasp the IAT sensor and pull it out of the duct.

3. Attaching bolt to lower air cleaner.

Tighten
Bolt to 6 Nm (53 lb. in.).

4. Front air input duct push in retainer.


REMOVE OR DISCONNECT AIR CLEANER SUPPORT
1. Upper and lower air cleaner.
2. Trans vent pipe from support.
3. Wiring harness from support.
4. Attaching bolt from air cleaner support.
5. Air cleaner support from vehicle.

INSTALL OR CONNECT
1. Air cleaner support to vehicle.
2. Attaching bolt to air cleaner support bolt to 10 Nm (8 lb ft).
3. Wiring harness to support.
4. Trans vent pipe to support.
5. Upper and lower air cleaner.