Coupe

Headlamp Assembly:

Remove or Disconnect

1. Open hood.
2. Raise headlamp access panel.
3. Electrical connector from headlamp.
4. Screw from headlamp support panel.
5. Two bottom screws from headlamp frame.
6. Assembly by lifting straight up.

Important
^ Do not apply pressure to plastic bubble of vertical aim indicator.

7. Two screws from headlamp retaining ring.
8. Rotate headlamp retaining ring away from headlamp.
9. Headlamp.

Install or Connect

1. Headlamp.
2. Two screws to headlamp retaining ring.

Tighten
^ Screws to 2 N.m (18 lb. in.).

3. Assembly.
^ Make sure two guide tabs drop into headlamp support panel.

Tighten
^ Two bottom screws to 5 N.m (44 lb. in.).
^ Screw to headlamp support panel to 5 N.m (44 lb. in.).

4. Electrical connector to headlamp.
5. Lower headlamp access panel.
6. Close hood.

Inspect
^ Vertical aim indicator bubble for correct headlamp aim.