Preliminary Testing

1. Check the hydrometer eye that is built into the vehicle Battery before troubleshooting the Charging System.
- Green eye - Battery is charged.
- Dark eye - Battery is discharged. Recharge Battery.
- Clear or yellow eye - Battery fluid is low. Replace Battery.
2. Check the Generator belt.
3. Check that the Generator connector terminals are clean and tight.
4. Check that Battery connections are clean and tight.
5. Check ENG EMIS and Fuse 39 Fuses.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (refer to General Troubleshooting Procedures). Diagnostic Aids
^ Go to System Diagnosis for diagnostic tests. Testing and Inspection