Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor:

REMOVE OR DISCONNECT
1. Sensor harness connector at sensor.
2. Sensor to block bolt (1).
3. Sensor from engine.

INSPECT
Sensor O-ring for wear, cracks or leakage. Replace if necessary. Lube new O-ring with engine oil before installing.

INSTALL OR CONNECT
1. Sensor to hole in block.
2. Sensor to block bolt (1).

Tighten
Bolt to 10 Nm (89 lb in)

3. Sensor harness connector.