SPS/EEPROM - Programming Chart

File In Section: 6E - Engine Fuel & Emission

Bulletin No.: 53-65-05

Date: October, 1995

Subject:
Chart to Assist Technician with SPS/EEPROM Programming

Models:
1995-96 Passenger Cars and Trucks

This bulletin is being issued to assist technicians with the reprogramming of vehicles. The following chart was developed to be used by technicians that are familiar with the Techline terminals, Tech 1 and all of its adapters:

IMPORTANT
If programming a new control module, you must request information from the new control module first.

Battery voltage must be between 11 and 14 volts. System to be programmed should NOT be connected to a battery charger. Incorrect voltage could cause programming and/or control module failure.










Programming Chart