Assemble

1. Inspect all components for excessive wear or damage and replace as required. Then clean and dry all components.

2. Install 2nd clutch piston and seal assembly into driven sprocket support. Lubricate seal with transaxle fluid to aid in assembly.

3. Install 2nd clutch spring and retainer assembly into driven sprocket support.




4. Compress 2nd clutch spring assembly with compression tool No. J-41232 or equivalent and assemble 2nd clutch spring retainer snap ring. Remove tool after snap ring is installed.




5. Air check 2nd clutch to verify proper operation of seals and clutch assembly.