Supplemental Inflatable Restraint (SIR)

Diagnostic Chart:

Wiring Diagram:

CIRCUIT DESCRIPTION
During the "Initiator Assembly Resistance Test" the DERM grounds the "Passenger Side Low" terminal "B7" and turns "ON" the driver current source at the "Driver Side High" terminal "B9." This causes a known amount of current to flow through the driver initiator circuit. By monitoring the difference between the voltage at the "Driver Side High" terminal "B9" and the "Driver Side Low" terminal "B8" the DERM calculates the combined resistance of the driver inflator module, SIR coil assembly, harness wiring CKTs 347A and 348A and connector terminal contact.

DTC WILL SET WHEN
The combined resistance of the driver inflator module, SIR coil assembly, harness wiring CKT 347A and connector terminal contact is above a specified value. This test is run during the "Initiator Assembly Resistance Test" when: 1) No "higher priority faults" are detected during "Turn-ON," 2)No "higher priority faults" are detected during "Continuous Monitoring" for one second, 3) No "Crank" signal present, 4) "Ignition 1" voltage is above a specified value.

ACTION TAKEN
DERM sets a diagnostic trouble code and sends a command to the instrument cluster to turn "ON" the "AIR BAG" warning lamp.

DTC WILL CLEAR WHEN
The ignition switch is turned "OFF."

DTC CHART TEST DESCRIPTION
Number(s) below refer to circled number(s) on the diagnostic chart.
1. This test determines whether the malfunction is in the driver inflator module circuitry or in the DERM wiring harness circuitry.
2. This test determines whether the malfunction is an open in CKT 347A.
3. This test determines whether the malfunction is in the driver inflator module or the SIR coil assembly.

DIAGNOSTIC AIDS
An intermittent condition is likely to be caused by a poor connection at: the yellow 2-way connector at the base of the steering column, DERM terminals or "B9," the connection at the top of steering column to the driver inflator module, a malfunctioning SIR coil assembly or a malfunctioning driver inflator module. The test for this diagnostic trouble code is only run while the "AIR BAG" warning lamp is performing the bulb check. When a scan tool "Clear Codes" command is issued and the malfunction is still present, the DTC will appear until the next ignition cycle.