Seat Shoulder Belt (Front) - Plastic Cover Comes Loose
File In Section: 09 - RestraintsBulletin No.: 99-09-40-001
Date: May, 1999
TECHNICAL
Subject:
Front Seat Shoulder Belt Plastic Cover at Pillar Will Not Stay Fastened (Replace Bolt)
Models:
1995-99 Chevrolet Cavalier (Coupe Only)
1995-99 Pontiac Sunfire (Coupe Only)
Condition
Some customers may comment that the front seat shoulder belt plastic cover will not stay snapped in place. This cover hides the bolt that attaches to the pillar.
Correction
Replace the shoulder belt to the pillar attaching bolt with new bolt P/N 15674851, using the following service procedure. Inspect the plastic cover for cracks or damage and replace the cover if necessary. Also replace the shoulder belt bolt and inspect the cover on the opposite side of the vehicle.
Service Procedure
1. Remove and inspect the plastic cover by pulling on the bottom of the cover (2).
2. Remove the shoulder belt to the pillar attaching bolt (1).
3. Install the new shoulder belt to the pillar attaching bolt (1) and tighten to 42 N.m (31 lb ft).
4. Install the plastic cover over the bolt head (2).
5. Repeat the procedure on the opposite side of the vehicle.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty use:
Labor Labor
Operation Description Time
Shoulder Belt to Pillar
C9050 Attaching Bolts - Replace Both 0.2 hr