P0713

DTC P0713 Fluid Temperature Sensor CKT High Input (1 Of 2):

DTC P0713 Fluid Temperature Sensor CKT High Input (2 Of 2):

Fluid Temperature Sensor CKT:

CIRCUIT DESCRIPTION

The Automatic Transmission Fluid Temperature (TFT) sensor is a negative coefficient thermistor. The sensor resistance changes with temperature. The Powertrain Control Module (PCM) provides a 5-volt reference to the sensor on circuit 1227. An open in circuit 1227 or circuit 452 results in high signal voltage. The TFT operating range is from -40 to +14O°C (-40 to +284°F).

When the PCM detects a voltage input greater than 4.92 volts in the TFT Sensor circuit, then DTC P0713 sets. DTC P0713 is a type A DTC.


CONDITIONS FOR SETTING THE DTC

^ No System Voltage Malfunction DTC P0560

^ The ignition is ON.

^ The PCM detects a transmission fluid temperature of -35°C (-31°F) or less (4.92 volts or more) for 7 minutes.


ACTION TAKEN WHEN THE DTC SETS

^ The PCM uses a default transmission fluid temperature of 170°C (338°F) for transmission operation.

^ The PCM illuminates the Malfunction Indicator Lamp (MIL).

CONDITIONS FOR CLEARING THE MIL/DTC

^ The PCM turns OFF the MIL after three consecutive ignition cycles without a failure reported.

^ A scan tool can clear the DTC from the PCM history. The PCM clears the DTC from the PCM history if the vehicle completes 40 warm-up cycles without a failure reported.

^ The PCM cancels the DTC default actions when the fault no longer exists and the ignition is OFF long enough in order to power down the PCM.


DIAGNOSTIC AIDS

^ Inspect the wiring for poor electrical connections at the PCM. Inspect the wiring at the transmission 7-way connector. Look for the following conditions:

- A bent terminal.

- A backed out terminal.

- A damaged terminal.

- Poor terminal tension.

- A chafed wire.

- A broken wire inside the insulation.


^ When diagnosing for an intermittent short or open condition, massage the wiring harness while watching the test equipment for a change.

TEST DESCRIPTION

The numbers below refer to the step numbers on the diagnostic chart.

3. A scan tool Trans. Fluid Temp. of -36°C (-33°F) or less indicates that this DTC is current.

4. This Step isolates the fault between the transmission harness or the engine harness.