Programming Procedure

Figure 3

1. Turn ignition switch "Off".

2. Using a fused jumper, jumper Data Line Connector terminal 8 (BLK/WHT) to terminal 4 (BLK). Close all doors.

3. Turn ignition switch "ON". Door locks cycle.

4. Press and hold "LOCK" and "UNLOCK" button on one transmitter. After a 30 second delay, the doors will lock and unlock.

5. To program extra transmitters, repeat Step 4. Do not turn OFF ignition. If switch is turned "OFF", the first transmitter will become inoperative.

6. Disconnect jumper from DLC.