Delayed Locking

Important:
The Delayed Locking feature must be initially enabled with the TECH 1 or TECH 2 to have access to this feature. The RFA module software for the feature is turned OFF on all new vehicles and service replacement parts. Use the procedure below to perform initial activation of Delayed Locking.

1. Connect TECH 1.

2. Select vehicle being programmed.

3. Select "Body".

4. Select "RFA".

5. Select "RFA Test".

6. Select "Set Options".

7. Select "Options 0".

Important:

^ Follow screen prompts and instructions.

^ During Step 8, use the EXIT key to change from one function screen to another. Do Not use the YES or NO keys. If YES or NO is pressed, other features may become disabled.

8. Scroll through screens until Delayed Locking is displayed, select .

9. Exit system.

10. Disconnect TECH 1.

11. Activate Delayed Locking feature by using the following procedure:

This feature allows the driver to delay the locking of the vehicle after the lock switch has been activated. Upon activating the lock switch with the driver's door open, a chime will sound to let the driver know that they are in the delayed locking mode. After all doors have been closed for 5 seconds, they will lock automatically. Opening any door before the 5 seconds have elapsed will cause the timer to reset once all doors are again closed. This feature can be programmed on or off for each transmitter.

To Turn Delayed Locking Feature Off (if currently enabled)

^ Hold lock switch on.

^ Press transmitter UNLOCK button, all doors unlock, Delayed Locking remains enabled.

^ Press transmitter UNLOCK again, all doors lock, Delayed Locking is disabled.

To Turn Delayed Locking Feature On (if currently disabled)

^ Hold lock switch on.

^ Press transmitter UNLOCK button, all doors lock, Delayed Locking remains disabled.

^ Press transmitter UNLOCK again, all doors unlock, Delayed Locking is enabled.