Troubleshooting Hints

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS:
1. Check I/P Fuse Block IGN(RUN/CRANK) CHIME CLSTR Fuse 1D by visual inspection.
2. Check Relay Center HTD STS PASS Fuse 9 and HTD STS DRV Fuse 10 by visual inspection.
3. Make sure that G201 and G202 are clean and tight.
4. Before component replacement, check for poor connections at related component and in-line harness connector terminal connections.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a Continuity/Voltage check with a system disconnected. These Circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a Voltage drop with the system operational (under load).
^ Check for proper installation of aftermarket electronic equipment which may effect the integrity of other systems.