Dual Zone A/C (CJ2)

AIR MIX VALVE ACTUATOR FOR DUAL ZONE A/C (CJ2)

Driver Air Mix Valve Actuator

Remove or Disconnect

1. Programmer. Service and Repair

2. Cover from programmer case (snaps open).

3. Electrical connector.

4. Screws and driver air mix valve actuator from vehicle.

-IMPORTANT: Driver temperature valve link rod after installation, refer to "Driver Temperature Valve Link Adjustment" Adjustments

Install or Connect

1. Screws after positioning driver air mix valve actuator.

2. Tighten screws to 1.4 Nm (12 lb.in.).

3. Electrical connector.

4. Cover to programmer case (snaps closed).

5. Programmer. Service and Repair


Passenger Air Mix Valve Actuator

Programmer Assembly:

-Disable SIR system. Air Bag(s) Arming and Disarming

1. I/P Compartment insert by pulling rearward.

2. Temperature valve link rod from plastic retainer on temperature valve.

3. Electrical connector.

4. Passenger air mix valve actuator screws and actuator.

-Adjust passenger temperature valve link rod after installation, refer to "Passenger Temperature Valve Link Adjustment" Adjustments

Install or Connect

1. Screws after positioning passenger air mix valve actuator.

2. Tighten screws to 1.4 Nm (12 lb.in.).

3. Electrical connector.

4. Temperature valve link rod.

5. I/P compartment by pushing forward.

-Enable SIR system. Air Bag(s) Arming and Disarming