HVAC Programmer

PROGRAMMER REPLACEMENT FOR AUTOMATIC A/C (C68)

HVAC Programmer:

Remove or Disconnect

-Disable SIR system. Air Bag(s) Arming and Disarming

1. PCM from attaching bracket.
- Let PCM hang, leave wires attached.
2. Vacuum and side electrical connector from programmer.
3. Temperature valve link rod.
- Reach up through PCM bracket to gain access to rod.
4. Programmer attaching screws.
5. Temperature valve actuator connector.
- Reach up through PCM bracket to gain access to connector.
6. Programmer.

Install or Connect

1. Programmer in position.
2. Temperature valve actuator connector.
- Reach up through PCM bracket to gain access to connector.
3. Programmer attaching screws.

Tighten
- Screws to 1.4 N.m (12 lb. in.).

4. Electrical and vacuum connectors.
5. Temperature valve link rod to air mix valve.

Adjust
-Temperature valve link rod after installation, refer to "Temperature Valve Link Adjustment". Adjustments

6. PCM to bracket.

-Enable SIR system. Air Bag(s) Arming and Disarming