Lock/Alarm/Lighting/Chime - Replacement Procedures
File in Section: 8 - Chassis/Body ElectricalBulletin No: 53-83-21
Date: October, 1995
SERVICE MANUAL UPDATE
Subject:
Section 8C - Procedures for Multi-Function Alarm, Lock and Lighting (MALL) Module, Perimeter Lighting Relay, Remote Function Actuator (RFA) Module and Multi-Function Chime Control Module (w/Y67)
Models:
1996 Buick LeSabre, Park Avenue
1996 Oldsmobile Eighty Eight, Ninety Eight
1996 Pontiac Bonneville
Please insert the following procedures in Section 80 of the Service Manual.
Multi-Function Alarm, Lock And Lighting (Mall) Module
(Refer to Figure 1)
Remove or Disconnect
1. Right lower I/P insulator, (2) screws, (1) light bulb.
2. Electrical connector(s).
3. MALL module from multi-use bracket. Press down on center tab of mounting bracket and slide module downward until mounting rails disengage.
Install or Connect
1. MALL module to multi-use bracket.
^ Align mounting rails on module with mounting bracket rails.
^ Slide module forward into place until locking tab engages.
2. Electrical connector(s).
3. Right lower I/P insulator.
Perimeter Lighting Relay
(Refer to Figure 1)
Remove or Disconnect
1. Right lower I/P insulator, (2) screws, (1) light bulb.
2. Electrical connector(s).
3. Slide perimeter lighting relay from multi-use bracket.
Install or Connect:
1. Slide relay onto bracket.
2. Right lower I/P insulator, (2) screws, (1) light bulb.
3. Electrical connector(s).
Remote Function Actuator (RFA) Module
(Refer to Figure 2).
Remove or Disconnect
1. Right lower I/P insulator, (2) screws, (1) light bulb.
2. Electrical connector(s).
3. Slide RFA module from multi-use bracket.
Install or Connect:
1. Slide RFA module onto bracket.
2. Right lower I/P insulator, (2) screws, (1) light bulb.
3. Electrical connector(s).
Multi-Function Chime Control Module (with Y67)
(Refer to Figure 2)
Remove or Disconnect
1. Right lower I/P insulator; (2) screws, (1) light bulb.
2. Electrical connector(s).
3. Slide chime module from multi-use bracket.
Install or Connect
1. Slide chime module onto bracket.
2. Right lower I/P insulator, (2) screws, (1) light bulb.
3. Electrical connector(s).