Operation CHARM: Car repair manuals for everyone.

P0107

Diagnostic Chart:




Diagnostic Chart (cont'd):




Wiring Diagram:





CIRCUIT DESCRIPTION

The Manifold Absolute Pressure (MAP) sensor responds to changes in intake manifold pressure (vacuum). The MAP sensor signal voltage to the PCM varies from below 2 volts at idle (high vacuum) to above 4 volts with the key ON, engine not running or at wide-open throttle (low vacuum). The MAP sensor is used to determine manifold pressure changes while the EGR flow test diagnostic is being run (refer to DTC P0401), to determine engine vacuum level for some other diagnostics and to determine barometric pressure (BARO). The PCM monitors the MAP signals for voltages outside the normal range of the MAP sensor. If the PCM detects a MAP signal voltage that is excessively low, DTC P0107 will be set.

CONDITIONS FOR SETTING THE DTC

- No Throttle Position (TP) sensor DTCs present.

- The engine is running.

- Throttle angle above 0%, if engine speed is less than 1000 RPM.

- Throttle angle above 6%, if engine speed is greater than 1000 RPM.

- The MAP sensor signal voltage is less than 0.1 volt.

- Above conditions present for longer than 200 3X reference periods (67 crankshaft revolutions).


ACTION TAKEN WHEN THE DTC SETS

- The PCM will illuminate the Malfunction Indicator Lamp (MIL) during the second consecutive trip in which the diagnostic test has been run and failed.

- The PCM will store conditions which were present when the DTC set as Freeze Frame and Fail Records data.


CONDITIONS FOR CLEARING THE MIL/DTC

- The PCM will turn the MIL OFF during the third consecutive trip in which the diagnostic has been run and passed.

- The history DTC will clear after 40 consecutive warm-up cycles have occurred without a fault.

- The DTC can be cleared by using the scan tool Clear Info function or by disconnecting the PCM battery feed.


DIAGNOSTIC AIDS

Check for the following conditions:

- Poor connection at the PCM. Inspect harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal to wire connection.

- Damaged harness. Inspect the wiring harness for damage. If the harness appears to be OK, observe the MAP display on the scan tool while moving connectors and wiring harnesses related to the sensor. A change in the dIsplay will indicate the location of the fault.

If DTC P0107 cannot be duplicated, the information included in the Fail Records data ban be useful in determining since the DTC was last set. If it is determined that the DTC occurs intermittently, performing the DTC P1107 Diagnostic Chart may isolate the cause of the fault.


TEST DESCRIPTION

Number(s) below refer to the step number(s) on the Diagnostic Table:

11. This vehicle is equipped with a PCM which utilizes an Electrically Erasable Programmable Read Only Memory (EEPROM). When the PCM is being replaced, the new PCM must be programmed.