M. Front Countershaft Bearing

^ Tools Required:
- J 37358-1, -2 Bearing Race Receiver and Case Support
- J 22912-01 Bearing and Gear Puller
- J 37359 Countershaft Bearing Remover
- J 8092 Universal Driver Handle
- J 37357 Countershaft Bearing and Race Remover and Installer

REMOVE OR DISCONNECT

NOTICE: Failure to support the case properly will result in permanent distortion of the case during bearing race removal.





1. Countershaft front bearing race and O-ring seal from the transmission case, using J 37358-1 with J 37358-2 and a press.





- Remove the front Countershaft bearing race only if it is worn or damaged.





2. Countershaft front bearing from the Countershaft using J 22912-01 with J 37359, J 8092 and a press.





INSTALL OR CONNECT
1. Countershaft front bearing onto the countershaft, using J 37357 with J 22912-01, J 8092 and a press.
2. New O-ring seal onto the Countershaft front bearing race.
- Lubricate the O-ring seal.
3. Countershaft front bearing race into the transmission case, using J 37357 with J 8092 and a press.
- Lightly tap the race into its bore until the O-ring seal is compressed.
- Use a press to install the race until its shoulder rests on the inside of the case.