Operation CHARM: Car repair manuals for everyone.

Troubleshooting Hints

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS:
The Powertrain Control Module (PCM) will "Inhibit" Cruise Control when there is a malfunction in any of the Cruise Control Inhibit Criteria. The PCM will "Inhibit" Cruise Control when:
^ The engine is "OFF"
^ An automatic transaxle is in "PARK" or "NEUTRAL."
^ A manual transaxle is out of gear (in "NEUTRAL").
^ There is high engine rpm (fuel cut-off).
^ There is high vehicle speed (fuel cut-off).
1. Check all cruise control inhibit criteria.
2. Check for Diagnostic Trouble Codes (DTC). Testing and Inspection
3. Check that Cruise Control Module Linkage is connected and moving freely.
4. Check Cruise Cable Adjustment.
5. Check Brake Switch for proper adjustment/alignment.

^ Make sure that Center High Mounted Stop lamp (CHMSL) is working. If inoperative, Cruise Module will be disabled.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a continuity/voltage check (refer to "General Troubleshooting Procedures,"). Diagnostic Aids
^ Check for proper installation of aftermarket electronic equipment which may effect the integrity of other systems (refer to "General Troubleshooting Procedures,").
^ Refer to System Diagnosis (ROAD TEST). Testing and Inspection