Outer Tie Rod

^ Tool Required:
- J 24319-01 Universal Steering Linkage Puller
- Or Equivalent

REMOVE OR DISCONNECT
1. Hex torque prevailing nut (1) from outer tie rod assembly (5).
2. Loosen jam nut (7).
3. Outer tie rod (5) from steering knuckle with J 24319-01.
4. Outer tie rod (5) from inner tie rod (12).

INSTALL OR CONNECT
1. Outer tie rod assembly (5) to inner tie rod (12). Do not tighten jam nut (7).
2. Outer tie rod (5) to steering knuckle, hex torque prevailing nut (1) to outer tie rod stud.
^ Tighten:
- Hex torque prevailing nut (1) to 10 Nm (7 ft. lbs.).
- Tighten nut an additional 210° of rotation.
^ Adjust toe by turning inner tie rod (12).

Important: Be sure rack and pinion boot (10) is not twisted or puckered during toe adjustment.

^ Tighten jam nut (7) against outer tie rod (5) to 68 Nm (50 ft. lbs.).