Troubleshooting Hints
PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS1. Check I/P Fuse Block CTSY/PWR MIR FUSE 6A by visual inspection.
2. Check for an open or short to ground in CKT 640 (ORN).
3. Make sure that G202 is clean and tight.
4. Before component replacement, check for poor connections at related component and in-line harness connector terminal connections.
5. Check for broken (or partially broken) wire inside of the insulation which could cause a system malfunction but prove "GOOD" in a continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
6. Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.