Troubleshooting Hints
1. Check RH I/P Power Distribution Center Fuse 2 by visual inspection.
2. Check RH MaxiFuse(R) Block "IGN SW" Fuse by visual inspection.
3. Check I/P Fuse Block CHIME/CLSTR/LCM Fuse 1D by visual inspection.
4. Check I/P Fuse Block RADIO Fuse 8D by visual inspection.
5. Check I/P Fuse Block WPR/WSHR/RAC Fuse 8E by usual inspection.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.
^ Refer to the Symptom Table for diagnostic procedure(s). Symptom Table