Height Sensor Check
1. Turn ignition "OFF", then "ON" to reset the sensor timer circuits.2. Raise vehicle on hoist. Be sure rear wheels are supported and vehicle is at proper trim height.
3. Check that wiring is securely connected to sensor and the harness ground wire is securely connected.
4. Disconnect link from sensor arm.
5. Move actuating arm up. There should be a 17 to 27 second delay before the compressor starts and the shocks start to inflate. As soon as the shocks fill, stop compressor by slowly moving actuating arm down.
6. Move actuating arm down below position where compressor stopped (approximately 1/2 inch). There should be a 17 to 27 second delay before the shocks start to deflate and vehicle lowers.