Clearing Codes
To clear error codes, connect one end of a jumper to pin 4 of the DLC connector. With the opposite end of the jumper, alternately plug into and remove from pin 3. Do this three times. Hold each connection for 1 second, and pause 1 second between connections.NOTE: Once the DLC circuit has cleared codes, it will turn off both driver select switch Light Emitting Diodes (L.E.D.'s) for 1 second, and then turn on the L.E.D.'s for 2 seconds. If the L.E.D.'s do not go out, then error codes have not been cleared successfully. Repeat the clearing sequence.