Troubleshooting Hints - Power Windows

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. Always check terminal contact before replacing any component.
2. Check I/P Fuse Block RADIO Fuse 8D by visual inspection.
3. Check RH MaxiFuse(R) Block PWR WDO/SR Circuit Breaker by visual inspection.
4. Check that grounds G201 and G202 are clean and tight
5. if windows move slowly, check that:
^ Windows are free of mechanical binding.. pivot joints are greased.
^ Battery is fully charged
6. If a motor's internal circuit breaker trips, it does not reset until voltage is removed from motor.
7. If power windows do not operate for approximately 10 minutes (or until a door is opened) after ignition switch is turned to OFF position, refer to Retained Accessory Power for diagnosis. Accessory Delay Module
8. Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a continuity/voltage check. (Refer to Troubleshooting Procedures.)
9. Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems. (Refer to Troubleshooting Procedures). Diagnostic Aids