Ignition Control Module/Coil Assembly

REMOVE OR DISCONNECT
1. Disconnect the negative battery cable.
2. Disconnect the electronic Ignition Control Module (ICM) 11 pin harness connector.

3. Remove the ignition coil and the electronic ICM assembly to camshaft housing bolts.

CAUTION: If boots adhere to spark plugs, use tool J 36011 or equivalent to remove by first twisting and then pulling upward on retainers. Reinstall boots and retainers on ignition coil housing secondary terminals. Boots and retainers must be in place on ignition coil housing secondary terminals prior to ignition coil and electronic ignition control module assembly installation or ignition control system damage may result.

4. Remove the ignition coil and the electronic ICM assembly from the engine.

INSTALL OR CONNECT
1. Install the spark plug boots and the retainers to the housing.
2. Install the ignition coil and the electronic ignition control module assembly to the engine while carefully aligning the boots to the spark plug terminals.

NOTE: ICM cover bolts must be installed with the isolator washers with the rubber side facing down.

3. Install the ignition coil and the electronic ignition control module assembly to the cam housing bolts, after coating the threads with P/N 1052080 or equivalent.
4. Install the cam housing bolts and tighten to 22 Nm (16 lb. ft.).
5. Connect the electronic ICM 11 pin harness connector.
6. Connect the negative battery cable.