Ignition Switch

Tilt Steering Column (1 Of 2):

Removing Ignition Switch:

Remove or Disconnect

1. Negative (-) battery cable.
2. Disable the SIR system.
3. Vehicle wire harness from ignition switch assembly (19).
4. Two tapping screws (20).
5. Ignition switch assembly (19).

Install or Connect

1. Ignition switch assembly (19).
2. Two tapping screws (20).

Tighten
- Tighten screws (20) to 1.7 N.m (15 lb.in.).

3. Vehicle wire harness to switch assembly (19).
4. If all service operations are completed, enable the SIR system.
5. Negative (-) battery cable.