Crankshaft Rear Oil Seal and Housing Installation

^ Tools Required - J 36005 Rear Crankshaft Seal Installer, or equivalent.

1. Press the new crankshaft seal into the housing. Use the J 36005. The installer also establishes the depth of the seal in the housing.
2. Position the new seal housing to block the gasket over the alignment dowel pins. The gasket is reversible.
3. Lubricate the lip of the crankshaft seal with engine oil.
4. Install the seal housing assembly.
5. Install the seal housing to the block bolts. Tighten the-bolts to 12 Nm (106 inch lbs.).