MAP Sensor Output Diagnosis

Diagnostic Chart:

Wiring Diagram:

Circuit Description

The Manifold Absolute Pressure (MAP) sensor measures the changes in the intake manifold pressure which result from engine load (intake manifold vacuum) and RPM changes; and convents these into a voltage output. The Powertrain Control Module (PCM) sends a 5 volt reference voltage to the MAP sensor. As the manifold pressure changes, the Output voltage of the sensor also changes. By monitoring the sensor output voltage, the PCM knows the manifold pressure. A lower pressure (low voltage) output voltage will be about 1.0 to 1.5 volts at idle. While higher pressure (high voltage) output voltage will be about 4.5 to 4.8 at Wide open Throttle (WOT). The MAP sensor is also used, under certain conditions, to measure barometric pressure, allowing the PCM to make adjustments for different altitudes. The PCM uses the MAP sensor to control fuel delivery and ignition timing.

Test Description

The numbers below refer to the step numbers on the Diagnostic Table.

Important: Be sure to use the same diagnostic test equipment for all measurements.

1. The OBD System check prompts the technician to complete some basic checks and store the Freeze Frame and Failure records data on the scan tool if applicable. This creates an electronic copy of the data when the fault occurs. The information is then stored on the scan tool for later reference.

4. Applying 34 kPa (10 in of Hg) vacuum to the MAP sensor should cause the voltage to be 1.5 to 2.1 volts less than the voltage at Step 3. Upon applying vacuum to the sensor, the change in voltage should be instantaneous. A slow voltage change indicates a malfunctioning sensor.

6. Check vacuum hose to sensor for leaking or restriction. Be sure that no other vacuum devices are connected to the MAP hose.

Important: Make sure electrical connector

remains securely fastened.

7. Move sensor electrical connector by hand (only) while watching scan tool to check for intermittent connection. Output changes greater than 0.10 volt indicate a bad connection. If OK, replace sensor.