Camshaft Position Sensor: Service and Repair

Removal Procedure
1. Disconnect the CMP sensor harness connector at the sensor.

2. Remove the CMP sensor bolt (2).

3. Remove the CMP sensor (1) from the camshaft housing (3).

Installation Procedure

Important: Inspect sensor O-ring for wear, cracks or leakage. Replace if necessary. Lubricate new O-ring with engine oil before installing.

1. CMP sensor (1) into camshaft housing (3).

2. CMP sensor bolt (2). Tighten the CMP sensor bolt to 10 Nm (88 lb. in.).

3. Sensor harness connector.