Ignition Lock Actuator & Lock Bolt Assembly - Floor Shift

This text applys also to the following components:
Ign Lock Actuator Asm
Lock Blots Asm


REMOVE OR DISCONNECT
1. Steering column lock cylinder set (13).
A. Turn lock cylinder (13) to "RUN" position.
B. Push against locking button on back side of steering column housing assembly (11) an remove lock cylinder (13).
C. Ground strap (15).
D. Lock pre-load spring (14).
2. Ignition lock actuator assembly (12) from steering column housing assembly (11) with needle nose pliers.
3. Lock bolt assembly (21).
A. Do steps 1 through 3 under "REMOVE OR DISCONNECT", refer to UPPER BEARING & HOUSING COMPONENTS.
B. Two tapping screws (23).
C. Lock bolt support bracket (22).
D. Lock bolt (21) from housing assembly (11).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Lock bolt assembly (21) and upper steering column housing components to steering column housing assembly (11).
A. Lock bolt assembly (21).
B. Lock bolt support bracket (22).
C. Two tapping screws (23).
^ Seat upper tapping screw (23) first and lower screw (23) second.
^ Tighten two screws (23) to 3.4 Nm (30 lb in).
D. Do steps 4 through 6 under "INSTALL OR CONNECT", refer to UPPER STEERING COLUMN HOUSING COMPONENTS.
2. Ignition lock actuator assembly (12) to housing assembly (11).
A. End of lock bolt (21) flush with support bracket (22).
B. Ignition lock actuator assembly (12) to housing assembly (11).
C. Rotate actuator (12) counterclockwise until it pushes out lock bolt (21) and actuator (12) seats into housing assembly (11).
D. Rotate actuator (12) clockwise to "RUN" position.
3. Lock pre-load spring (14) to housing assembly (11).
4. Ground strap (15).
5. Steering column lock cylinder set (13).
^ Key installed in lock cylinder (13).
^ Ensure sector is in "RUN" position.
^ Line up locking tab with slot in housing assembly (11) and push into position.