Steering Column Housing Assembly - Floor Shift

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- Or Equivalent

REMOVE OR DISCONNECT
1. Do all steps, under "REMOVE OR DISCONNECT", refer to SIR COIL ASSEMBLY.
2. Do all steps, under "REMOVE OR DISCONNECT", refer to UPPER STEERING COLUMN HOUSING COMPONENTS.
3. Three adapter screws (10) securing steering column housing assembly (11) to support mounting adapter (46).
4. Steering column housing assembly (11).
^ Vehicle wire harness from ignition switch assembly (19).

Disassemble
A. Three adapter screws (10) securing mounting plate (17) to steering column housing assembly (11).
B. Mounting plate (17) and bearing retainer (18).

Assemble
A. Bearing retainer (18) and mounting plate (17).
B. Three adapter screws (10) securing mounting plate (17) to steering column housing assembly (11).
^ Tighten three screws (10) to 5.7 Nm (50 lb in).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Steering column housing assembly (11) to support mounting adapter (46).
2. Three adapter screws (10).
^ Tighten three screws (10) to 5.7 Nm (50 lb in).
3. Vehicle wire harness to ignition switch (19).
4. Do steps 1 through 5, under "INSTALL OR CONNECT", refer to UPPER STEERING COLUMN HOUSING COMPONENTS.
5. Do all steps , under "INSTALL OR CONNECT", refer to SIR COIL ASSEMBLY.