Upper Steering Column Housing Components - Floor Shift

This text also apply to following components:
Shaft Lock
Turn Signal Cancel Cam Asm
Upper Bearing Spring
Upper Spacer


^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- Or Equivalent

REMOVE OR DISCONNECT
1. Do steps 1 through 5, under "REMOVE OR DISCONNECT", refer to SIR COIL ASSEMBLY.
^ Let sir coil assembly (3) hang freely.
2. Shaft lock retaining ring (5) using J 23653-SIR to push down shaft lock (6).
^ Dispose of ring (5).
3. Shaft lock (6).
4. Turn signal cancel cam assembly (7).
5. Upper bearing spring (8).
6. Upper bearing spacer (9).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Upper bearing spacer (9).
2. Upper bearing spring (8).
3. Turn signal cancel cam assembly (7).
4. Shaft lock (6).
^ Align inner block tooth of lock plate to block tooth of steering shaft assembly (26).
^ Lubricate with grease, synthetic (service kit).
5. New shaft lock retaining ring (5) using J 23653-SIR to push down shaft lock (6).
^ Ring (5) must be firmly seated in groove on shaft.
6. Do all steps, under "INSTALL OR CONNECT", refer to SIR COIL ASSEMBLY.