Intermediate Servo Assemble

1. Inspect the intermediate servo spring washer (130) and the spring (131) for damage or distortion.
2. Inspect the servo piston (133) for nicks, scratches, cracks, or porosity.
3. Inspect the piston seal groove for damage.
4. Inspect the servo cover (137) for damage, cracks, or porosity.





5. Install the intermediate servo spring washer (130) and the spring (131) onto the intermediate servo pin.
6. Install the servo piston (133) onto the pin.
7. Install the snap ring retainer (135).





8. Lubricate the inner and the outer servo piston lip seals (134, 132) with TRANSJEL(tm) and assemble the seals onto the servo piston.
9. Lubricate the servo pin fluid seal (128) with TRANSJEL(tm) and assemble the seal onto the servo pin.





10. Install the third accumulator exhaust spring (125) into the case.
11. Install the accumulator exhaust valve (126) into the case.





12. Install the intermediate servo pin and piston assembly (133) into the case.
13. Install the servo cover gasket (136).
14. Install the servo cover (137), the low and reverse fluid pipe retainer (140), and four pipe retainer bolts (141).
- Tighten the bolts to 24 Nm (18 ft. lbs.).