Operation CHARM: Car repair manuals for everyone.
Home >> Pontiac >> 1997 >> Sunfire L4-144 2.4L DOHC VIN T SFI >> Repair and Diagnosis >> Transmission and Drivetrain >> Drive Axles, Bearings and Joints >> Axle Shaft Assembly >> Service and Repair >> On-Vehicle Service >> Output Axle Shaft Sleeve

Output Axle Shaft Sleeve

^ Tools Required:
- J 41227 Axle Shaft Sleeve Removal Tool
- J 41228 Axle Shaft Sleeve Installation Tool

REMOVE OR DISCONNECT
1. Raise and support the vehicle.
2. Drive axle assembly.
3. Transaxle side cover assembly.





4. Sleeve from output shaft using puller J 41227.

Inspect
- Inspect the sleeve for excessive wear, scratches or nicks that may cause a leak or damage to the seal portion. If sleeve appears damaged, it must be replaced.

INSTALL OR CONNECT
1. New sleeve on output shaft using J 41228. Sleeve installation tool must be installed on shaft such that the collar is located in the snap ring groove.
2. Two new snap rings on the output shaft.
3. Install seal protector into side cover to prevent the seal from rolling.
4. Transaxle side cover assembly.
5. Drive axle assembly.
6. Lower vehicle.

Inspect
- For leaks.
- Oil level, refer to "Transaxle Oil Level Checking Procedure."

pro multis · About Operation CHARM