ETR AM/FM Stereo (UM7)

UM7 Radio:

UPPER KNOB
This knob turns the radio assembly on and off. Rotate knob to control volume. The control ring behind the knob is the balance control. Turn the ring clockwise to move speaker balance to the right and counterclockwise to move speaker balance to the left. Press the knob to recall the frequency when the radio is playing.

LOWER KNOB
Turn the knob to manually select radio stations. When the radio assembly is on, press the knob to choose either the AM or the FM band. The control ring behind the lower knob fades the sound between the front and rear speaker assemblies.

BASS AND TREBLE CONTROLS
Slide the "TREB" lever up to increase treble and down to decrease treble. Slide the "BASS" lever up to increase bass and down to decrease bass. If a station is weak and noisy, move the "TREB" lever down to reduce the noise.

PUSH BUTTONS
To preset four AM stations and four FM stations:
1. Tune in desired station.
2. Press "SET." Within 5 seconds, press a station button.

Three additional stations on each band can be preset by pressing a pair of push buttons next to each other at the same time:
1. Tune in the desired station.
2. Press "SET."
3. Within 5 seconds, press two push buttons that are next to each other at the same time. The station will return when the same two buttons are pressed again.
The radio will tune to the preset station when the push button or button pair is pressed.

If electrical power is interrupted by a blown fuse or a discharged battery, the stations must be reset.

CLOCK
To set the clock display, the ignition lock cylinder must be in the "ACCESSORY" or "RUN" position and the radio assembly must be off. To set the clock:
1. Push "SET."
2. Within 5 seconds, push and hold "SEEK left" until the correct hour appears.
3. Then push and hold "SEEK right" until the correct minute appears.

SEEK AND SCAN FEATURE
The 2000 series radio assemblies have "SEEK" and "SCAN" features for electronic station tuning up and down the band. Push the "SEEK" right or "SEEK" left and the radio will tune to the next higher or lower station with enough signal strength to be heard clearly, and will stay there.

"SCAN" is a two-button sequence. To "SCAN" to the next higher station, press "SEEK" right and hold it there while you press "SEEK" left To scan to the next lower station, press "SEEK" left and hold it there while you press "SEEK" right. The radio will move to the next strong station. It will pause there a few seconds, then move to the next strong station. When the radio reaches the end of the band, it will return to the other end of the band and continue to "SCAN." This will continue until the "SCAN" mode is terminated. To terminate the "SCAN" mode, press both buttons again or press the upper knob.