ETR AM/FM Stereo/Compact Disc (UN0)

UN0 Radio:

VOLUME KNOB
This knob turns the radio assembly on and off. Rotate knob to control volume.

"SCV" (SPEED-COMPENSATED VOLUME)
Rotate the ring behind the volume knob to automatically compensate for increase in road noise levels at higher speeds. It causes the volume to increase slowly as speed increases. When working properly, the subtle changes in volume should not be noticeable to the driver. "SCV" can be turned off for normal driving.

"AM/FM"
Press "AM/FM" to receive "AM," "FM1" or "FM2." The lighted display shows the selection.

TUNE KNOB
Push the "TUNE" knob to release it. Rotate the knob to choose desired radio stations. Push the knob back in to store it after tuning.

"RECALL"
Press "RECALL" to recall the station being played or the clock display. Press "RECALL" also to display the time when the ignition is off.

"AUTO TONE"
Press "AUTO TONE" to choose preset treble and bass equalization settings designed for "ROCK," "NEWS," "POP," "JAZZ" and "CLASSICAL." Each lime "AUTO TONE" is pressed, another setting will appear on the display. When "MAN" (manual) appears, control of the tone will be back w the treble and bass knobs.

"SEEK"
Press "SEEK" right or left "SEEK" and the radio will tune to the next higher or lower station and will stay there.

"PSCAN"
Press "PSCAN" to hear each of the preset stations for a few seconds. To stop at a chosen station, press "PSCAN" again.

CLOCK
To set the clock display on the radio assembly:
1. Press and hold "HR" (hour) until the correct hour appears.
2. Press and hold "MIN" (minute) until the correct minute appears. There will be a two second delay before the clock goes into the time-set mode.

PRESET BUTTONS
To preset six AM stations, six FM1 stations and six FM2 stations:
1. Tune in desired station.
2. Choose a preset "AUTO TONE".
3. Press and hold one of the six push buttons for 5 seconds. The station will fade out then return when set. The preset station will return whenever that button is pressed.

Repeat these steps for each push button.

SPEAKER ADJUSTMENT
Balance Knob: Push "BAL" knob to release it. Turn the knob to move the sound between the right and left speakers. Push the knob back in to store it when not adjusting.

Fade Knob: Push "FADE" knob to release it. Turn the knob to move the sound between the front and rear speakers. Push the knob back in to store it when not adjusting.

BASS AND TREBLE CONTROLS
Push the "TREB" knob to release it. Rotate the knob to the right to increase treble and to the left to decrease treble. Push the knob back in to store it when not adjusting.

Push the "BASS" knob to release it Rotate the knob to the right to increase bass and to the left to decrease bass.

If a station is weak and noisy, rotate the "TREB" knob to the left to reduce the noise.