Cruise Control Module: Service and Repair

Cruise Control Module To Bracket:

Cruise Control Module Mounting:

The cruise control module assembly is mounted on the right front strut tower. The module assembly has an electronic controller and an electric stepper motor to vary the throttle with each different cruise control mode. The module assembly is not serviceable.

Remove or Disconnect
1. Negative battery cable.
2. Cruise control cable at engine bracket and Throttle Body Injection, (TBI) cam.
3. Cruise control cable from module assembly.
4. Electrical connector from module assembly.
5. Two 10 mm nuts from mounting studs (2.2L). Slide module from mounting bracket (2.4L).
6. Module assembly from right strut tower (2.2L). Module assembly from front of dash (2.4L).
7. Module assembly from mounting bracket (2.2L).

Install or Connect
1. Module assembly to mounting bracket (2.2L).

IMPORTANT Do not pre-tap screws to module without mounting bracket in between the module and the screw. The added length of the screw may damage the cruise control module.

Tighten
^ Nuts to 12 N.m (106 lb. in.)
2. Module assembly to strut tower (2.2L). Module assembly to Front of Dash (2.4L).
3. Two nuts (2.2L).
Tighten
^ Nuts to 25 N.m (18 lb. ft.)
4. Electrical connector to module.
5. Cruise control cable to module assembly.
6. Cruise control cable to engine bracket and TBI cam.
7. Adjust Cruise Control Cable. Refer to "Adjust Cruise Control Cable".
8. Negative battery cable.