Hose/Line HVAC: Service and Repair

Compressor/Condenser Hose Assembly - 2.2L:

Compressor/Condenser Hose Assembly - 2.4L:

Tool Required:
J 39500 R-134a Refrigerant Recovery, Recycling, and Recharging Station

Remove or Disconnect

1. Recover refrigerant.
2. Switch connection on discharge line.
3. Cruise control module (if equipped).
4. Suction line (accumulator to compressor) at accumulator.
5. Upper closeout panel.
6. Connection at the condenser.
7. Raise vehicle.
8. Block fitting at the rear head of the compressor.
9. Compressor/condenser hose assembly.

Important

^ Remove and discard all used O-ring seals and "Sealing Washers".

Install or Connect

1. Compressor/condenser hose assembly.
2. Block fitting to rear head of compressor using new "Sealing Washers".
3. Lower vehicle.
4. Suction line at the accumulator using a new O-ring seal.
5. Connection at the condenser using new O-ring seals.
6. Switch connection on discharge line.
7. Cruise control module.
8. Upper closeout panel.
9. Evacuate and charge A/C system.
10. Check system operation and leak test.