Wheel Cover: Service and Repair

REMOVE OR DISCONNECT
1. Raise vehicle and suitably support.
2. Tire and wheel assembly.
3. Hub cap.
^ Place a block of wood approximately 50 mm (2 inches) in diameter with a squared off end against the back surface of the cap. A sharp hammer blow on the block of wood will remove the cap.

INSTALL OR CONNECT
1. Hub cap
^ Place cap into position at wheel opening and place a block of wood at least 75 mm (3 inches) on diameter against cap face. Install cap by striking block of wood with hammer.

NOTICE: Failure to hit cap squarely without the load distributed evenly could result in permanent damage to the cap.

2. Tire and wheel assembly.