Rear Hub and Bearing

REAR HUB/BEARING






REMOVE OR DISCONNECT
1. Raise vehicle.
2. Wheel and tire assemblies.
3. Brake drum.

NOTICE: Do not hammer on brake drum as damage to the assembly could result.

4. Rear ABS wheel speed sensor wire connector.
5. Remove hub and bearing assembly from axle. The top rear attaching bolt/nut will not clear the brake shoe when removing the hub and bearing assembly. Partially remove hub and bearing assembly prior to removing this bolt.

INSTALL OR CONNECT
1. Connect rear ABS wheel speed sensor wire connector.
2. Hub and Bearing assembly. Position top rear attaching bolt in hub and bearing assembly prior to the installation in the axle assembly.
^ Tighten hub and bearing to axle bolts to 60 Nm (44 lb ft).
3. Brake drum.
4. Wheel and tire assembly.
5. Lower vehicle.