Accelerator Control Cable Replacement

Removal Procedure
1. Remove left sound insulator.
2. Remove release cable retainer from lever assembly.
3. Depress cable tangs and push forward toward engine compartment.
4. Remove air intake duct.
5. Remove screws (1) to accelerator control splash shield.
6. Remove the shield (5).
7. Remove the cruise control cable if equipped.
8. Depress tangs on cable through cable bracket (3).
9. Remove cable (2) from cam.

Installation Procedure
1. Route cable through cable bracket (3).
2. Press cable upward through bracket.
3. Ensure tangs expand and properly seat.
4. Install the cruise control cable.
5. Install the accelerator control splash shield (5).
6. Install the screws (1) to shield. Tighten the screws to 8 Nm (71 lb. in.).

7. Install the air intake duct.
8. Route cable through cowl.
9. Slip accelerator cable (2) through slot in rod and then install retainer in rod, being sure it is seated.

Important: Flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2.0 in) of moving parts of accelerator linkage outboard of support unless routing is positively controlled.

10. Check for correct opening and closing positions by operating accelerator pedal. Make sure that the throttle valve reaches wide-open throttle position. If it does not, inspect for damaged or bent brackets, levers, or other components; or, for poor carpet fit under the accelerator pedal.
11. Install the left sound insulator.