Front Wheel Speed Sensor

Front Wheel Speed Sensor Removal:

REMOVE OR DISCONNECT
1. Raise and support vehicle on suitable hoist.
2. Front sensor electrical connector.
3. Retaining bolt.
4. Front wheel speed sensor. If sensor will not slide out of knuckle, remove brake rotor and use a blunt punch or equivalent tool to push sensor from back side of knuckle. If sensor locating pin breaks off and remains in knuckle during removal, proceed as follows.
a. Remove brake rotor and remove broken pin using a blunt punch.
b. Clean hole using sand paper wrapped around a screwdriver or other suitable tool. Never attempt to enlarge the hole.

INSTALL OR CONNECT
1. Front wheel speed sensor on mounting bracket. Make sure front wheel speed sensor is properly aligned and lays flat against bosses on knuckle.
2. Retaining bolt. Tighten retaining bolt to 12 Nm (107 inch lbs.).
3. Front sensor electrical connector to front wheel speed sensor.