Front Wheel Speed Sensor Wiring

Right Front Wheel Speed Sensor Harness:

Left Front Wheel Speed Sensor Harness:

CAUTION:
^ The front wheel speed sensor wiring is subjected to the same motion as a spring or shock absorber. Consequently, any repair to the front wheel speed sensor wiring circuits in the control arm section of the wiring harness will result in stiffening and eventual failure due to wire fatigue.

^ The front wheel speed sensor wiring is not repairable in the control arm section of the wiring harness. This section of the wiring harness must be replaced with the appropriate wiring harness service kit "pigtail." The splice must be located within the main branch of the engine harness. Do not attempt to solder, splice, or crimp this section of the wiring harnesses as eventual failure will likely result.

REMOVE OR DISCONNECT
1. Connector from wheel speed sensor.
2. Harness attaching clips for control arm and splash shield.
3. Lower vehicle.
4. Harness attaching clips from strut tower.
5. Cut wheel speed sensor wiring circuits within main engine harness.
6. Strip insulation on engine harness leads and new wheel speed sensor harness leads.

INSTALL OR CONNECT
1. Splice sleeve provided in jumper harness kit over each engine harness leads.
2. New wheel speed sensor harness leads to engine harness leads (matching color) and crimp connections.
3. Heat shrink tube lightly to seal.
4. Harness attaching clip to strut tower.
5. Raise and support vehicle on suitable hoist.
6. Harness attaching clips to control arm and splash shield.
7. Connector to wheel speed sensor.